I fabricate the parts of the Scotch yoke for my Gingery shaper. I cast the pieces. Next I machined them to roughly square stock. I cast and machined the bearings to be a press fit into the parts.
Next up is assembling the yoke and attaching it to the ram.
Sign-up for early access to project videos:
http://makercise.com/signup
Support this project directly: http://patreon.com/makercise
Check out the full shaper project playlist:
https://www.youtube.com/playlist?list=PL9d6LkFNP1fEdw-SPCSIUX8NP0x8McHtW
C
آی-ویدئو